 printable version
Setting
When you install must be replaced with new bolts, nuts, washers, clamp collet (before installing, apply the hole knuckle grease G 000 650). Installation is made in sequence, return to removal, taking into account the following. Install the shock absorber base so that the hole in the bottom slot of the spring in the side of the engine compartment.
| Fig. 12.6. Location bolts bottom of the shock absorber (1) and fixing ball joints upper arm front suspension (2)
|
Install the plug in the bottom of the shock absorber on the guide arm and fix a bolt 1 (see. Fig. 12.6) and the nut. Tightening the nuts make on the car standing on wheels. Install the lower ball joint holding arm in the knuckle and secure with a nut, tightening it to a torque of 90 Nm.
| Fig. 12.4. Fasteners top of the knuckle 1 - a nut and bolt ball joints of the upper arm front suspension; 2 - ball joints of the upper arm front suspension; 3 - the bolt rod end; 4 - a bolt with square head
|
Attach the upper part of the shock absorber bolts, having tightened their moment of 20 Nm. Secure the ABS sensor on the brake caliper bracket. Install the rubber plugs. Apply a thin layer of grease on the collar of the hub centering disc wheels. Install the wheel and secure it with screws. Lower the car and tighten the wheel bolts torque of 120 Nm.
| 
