 printable version
Withdrawal
Using the screwdriver blade as a lever, remove the caps from the central part of the drive wheels. Raise the vehicle and remove the rear wheels.
| Fig. 12.21. Location screws protective panel
|
Remove the access panel located in front of the rear axle (Fig. 12.21).
| Fig. 12.20. Elements of design of the rear suspension front-wheel drive: 1 - lower spring seat; 2 - Mount the speed sensor; 3 - speed sensor; 4 - coil spring; 5 - a nave; 6 - an arm; 7 - a nut; 8 - a bolt, M12x1,5x90, 110 N ?� m; 9 - housing bracket; 10 - bolt 10 Nm; 11 - a bolt, M12x1,5x60, 110 Nm and tighten 90 ?�; 12 - a beam; 13 - a bolt, M14x1,5x190, 120 Nm and tighten 90 ?�; 14 - a belt; 15 - threaded holes
|
Turn out bolts and remove a casing 9 (see. Fig. 12.20) brackets 6.
| Fig. 12.22. Using a lifter VAG 1383A with adapter VAG 1359/2 to lift the lever rear beam: 1, 2 - bolts
|
Install lifters VAG 1383A with adapters VAG 1359/2 under the arms and lift the rear of the beam so that the rear beam support device (Fig. 12.22). Remove the screws 2 (Fig. 12.22) on both sides of the rear beam. If necessary, lower the rear beam and remove the coil springs. Remove the nuts holders of the parking brake cable to the elements of the rear beam.
| Fig. 12.23. Using the devices 80-200 to remove the bracket speed sensor
|
| Fig. 12.24. Location clamps wire speed sensor and the brake pipe on the rear beam
|
Release the speed sensor wire from clips on the back of the beam (Fig. 12.24). Release the brake pipe from the clamps on the rear beam (see. Fig. 12.24).
| Fig. 12.25. Location bolts of the rear wheel brake caliper
|
Remove the brake caliper mounting bolts, remove the brake pads and soft wire fix calipers on the body (Fig. 12.25). Remove the brake discs. Marker mark the position of the left and right brackets on the body.
| Fig. 12.26. Location bracket bolts rear beam
|
Remove the bolts attaching the brackets and remove the back beam (Fig. 12.26).
| 
