|
|
 printable version
The water pump of engine DOHC
1 - a bolt, 8-10 N ??? m;
2 - an arm of the generator;
3 - the water pump; | 4 - a lining;
5 - a bolt, 12-15 N ??? m. |
Withdrawal
| PERFORMANCE ORDER | | 1. Disconnect the negative battery terminal. Drain the coolant into a suitable container and disconnect the hose from the union exit coolant water pump. | | 2. Remove the V-ribbed belt and the water pump pulley. | | 3. Remove casings of a gear belt and a tension roller of a gear belt. | | 4. Remove the bolts of the water pump, then remove the generator support. | | 5. Remove the water pump from the engine block. |
|
Check
| PERFORMANCE ORDER | | 1. Check each part for cracks, damage or wear and replace if necessary the pump assembly. | | 2. Turn the shaft of the water pump and check for smooth rotation in the absence of noise. |  | 3. Check for leaks from the coolant pump. If there is a leak from the hole A faulty seal of the pump. If necessary, replace the water pump. |
|
Setting
| PERFORMANCE ORDER | | 1. Remove any remnants of gaskets and foreign material sealing surface of the water pump. | | 2. Replace the water pump new gasket, install the pump and secure it with screws. Torque: 12-15 N ??? m | | 3. Set the toothed belt tensioning pulley and adjust the belt tension. | | 4. Install the timing belt covers. | | 5. Install the water pump pulley and V-ribbed belt, and then adjust the belt tension. | | 6. Fill in the required amount of cooling required coolant. |  | 7. Connect the cable to the negative terminal of the battery. Start up the engine and check for leaks from the cooling system. |
|
|
|
