REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
			Manual Transmission
			Automatic transmission
				Technical data
				The control lamp fault (MIL)
				Diagnostic trouble codes
				Read fault codes
				Check the transmission fluid pressure
				Testing of teamwork of an automatic transmission and the engine for the motionless car (stall test)
				Check the fluid level in automatic transmission
				Check the operation of the selector lever
				Adjustment of the switch indicate the position of the selector lever
				Adjusting the servo compulsory inclusion downshift
				Adjust the line pressure
				Replacement of an oil sealing ring of a power shaft
				Replacement of a cable drive speedometer
				Removing and installing transmission
				Repair Transmission
				Lever
				Control Cable
				Repair of the selector lever
		Axes and power shafts
		Suspension
		Steering
		Brakes
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

Read fault codes

PERFORMANCE ORDER

Using the scanner HI-SCAN
1. Turn off the ignition.
2. Connect the scanner to the HI-SCAN diagnostic socket.
3. Turn on the ignition.
4. On the HI-SCAN scanner read the fault codes.
5. Eliminate the malfunction.
6. Clear the DTCs.
7. Disconnect the scanner from the HI-SCAN diagnostic socket.
Using the voltmeter
8. Turn the ignition off.
9. Connect a voltmeter to terminal 1 of the diagnostic socket.
10. Connect the L-15 wire to the diagnostic socket.
11. Sample output is shown on the voltmeter.
12. Read DTCs.
	13. Clear the DTCs.