| 1. Disconnect in the first place, the wire from the negative terminal of the battery, and then - on the positive. Remove the drain plug and drain into a suitable container gear oil from the gearbox. |
| 2. Remove the clutch slave cylinder. |
| 3. Remove the air filter. |
| 4. Remove the battery and battery support. |
 | 5. Remove the cable gear selection. |
| 6. Disconnect the reverse gear switch. |
| 7. Remove the speedometer cable. |
| 8. Remove the clutch hydraulic tube and close the end of the pipe with a suitable plug. |
 | 9. Remove the cover from the engine and gearbox casing side. |
| 10. Remove the front and rear brackets. |
| 11. Remove the right front wheel. |
| 12. Remove the bolt ball joint pillar. |
| 13. Insert mount between an internal SHRUS drive shaft and a transmission and easy blow on mount take a power shaft from a transmission. |
 | 14. Remove the starter. |
| 15. Special adaptation 09400-29000 support the engine so that the engine weight was perceived device. |
| 16. Remove the left arm of a transmission. |
| 17. Remove the upper bolts gearbox. |
 | 18. Remove the clutch housing. |
| 19. Support a transmission jack. |
| 20. Remove the lower bolts gearbox. |
| 21. Remove the clutch cover and clutch disc. |
| | 22. Remove the flywheel. |
