REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Sephia / Shuma (1995 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Sephia / Shuma
		Maintenance
		Engine
		Greasing system
		Cooling
		The power supply system and release
		Fuel system
		Ignition system
		Coupling
		Manual transmission
		Automatic Transmission
		Axes and power shafts
		Steering
		Wheels and tires
		Brakes
		Suspension
		Body
			Technical data
			Front bumper
			Rear bumper
			The front door
			Conformal door seal
			Door hinges and door lock strike plate
			Door lock
			Inner Door handle
			The outer door handle
			Cylinder door lock
			Window switches
			Power windows
			Glass doors
			Backdoor
			Spotlight
			High level brake light
			The rear combination lamp
			Ceiling
			Hood
			Sound signal
			Device combination
			Repair of the instrument cluster
			Replacing bulbs dash
			Printed circuit board
			The top decorative overlay of the panel of devices
			Switches
			The central panel
			Cover center console
			The center console
			Dimmer dashboard
			The left and right lattices of a heater of a windscreen
			The left and right lateral lattices of a heater
			Ducts heating and ventilation systems
			Floor ducts
			Glovebox
			A cable of opening the bonnet
			Handle opening the bonnet
			Dashboard
			The control panel heating and ventilation
			Door mirror
			Replacing the glass door mirror
			The front seats
			Upholstery front seatback
			The upholstery of the front seat
			The leaning back hinge of a forward seat
			Rear seat
			Seat belts
			Lock the front seat
			Front shoulder belt
			Rear seat belts
			Bracket rear seat belt
			Shoulder rear seat belt
			The top furnish of a forward rack
			The bottom furnish of the central rack
			The top furnish of the central rack
			Finish the back of the rack
			Finishing stand legs
			Front side door trim
			Rear door trim
			The trunk lid
			The hinge lid
			Windshield washer hose
			Engine windshield washer
			Wiper Arm
			Sprayers
			Replacing the wiper blades
			Traction wiper
			Wiper Motor
			Distances between body points
		The air conditioning system
		Electrical equipment

printable version

Traction wiper

Withdrawal

PERFORMANCE ORDER

1. Remove the wiper arms.
2. Remove the wiper motor.
3. Remove the seven screws and release the four clips securing the plenum grille situated at the base of the windshield.
	4. Remove the grille plenum.
5. Remove the four nuts pivots rods.
	6. Remove the rod wiper from the plenum, moving them towards the driver.

Setting

PERFORMANCE ORDER

1. Insert the wiper rod in the plenum, moving them from the driver.
2. Install the hinge axis and secure them with bolts and nuts.
	3. Replace traction drive wiper motor crank.
4. Install the wiper motor.
5. Replace the grille plenum.
6. Install the wiper arms.
	7. Check the wiper blades. Wiper the driver's side must be at a distance of 30 ?± 2 mm from the base of the windshield, and brush on the passenger side - at a distance of 37 ?± 2 mm from the base of the windshield.

« previos page
Replacing the wiper blades

next page »
Wiper Motor