REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Sephia / Shuma (1995 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Sephia / Shuma
		Maintenance
		Engine
		Greasing system
		Cooling
		The power supply system and release
		Fuel system
		Ignition system
		Coupling
		Manual transmission
		Automatic Transmission
		Axes and power shafts
		Steering
		Wheels and tires
		Brakes
		Suspension
		Body
		The air conditioning system
		Electrical equipment
			Technical data
			Electrical circuits
			Circuit breakers
			Accumulator battery
			Check of level and density of electrolit and gymnastics
			Maintenance-free batteries
			Wires and terminals
			Charging standard batteries
			Starter
			The switch of blocking of a starter
			Removing and installing starter
			Repair of starter
			Check of the traction relay
			Check of brushes and brush holder
			Checking the stator coils
			Check rotor
			Generator
			Alternator drive belt
			Removing and installing the generator
			Repair the generator
			Check the rear window defogger
			Airbag
			The front passenger airbag
			Coiled Wire
			Troubleshooting System start-up and troubleshooting
			Electrical circuits

printable version

Removing and installing the generator

Withdrawal

PERFORMANCE ORDER

1. Disconnect the negative battery terminal.
2. Remove the cap from the terminal to the generator.
3. Remove the nut fastening wires to the terminals of the generator.
4. Remove the wire from the terminal to the generator.
	5. Disconnect the connectors L and S generator.
6. Loosen the central bolt of fastening of the generator and the mounting bolt.
	7. Turn the adjusting bolt, loosen the tension of the alternator drive belt.
8. Remove the drive belt from the alternator pulley.
9. Remove the bolt tensioning pads.
10. Remove the center bolt of the generator.
11. Loosen the adjusting plate bolt and turn the plate.
12. Remove the generator from the engine. Remove the generator from the engine.

Setting

PERFORMANCE ORDER

1. Place the generator on the engine.
2. Screw but do not tighten the central bolt of the generator.
3. Turn the adjustment plate in its original position.
4. Install the cover of the adjustment plate.
5. Screw but do not tighten the bolt tensioning pads.
6. Install the alternator drive belt on alternator pulley.
7. Turn the adjusting screw to adjust the tension of the alternator drive belt. Deflection alternator drive belt The new 8-9 mm Second hand 9-10 mm
	8. Tighten the bolt pad adjusting plate. Torque: 19-26 N ??? m
9. Tighten the central bolt and bolt adjusting plate. Torque: 38-51 N ??? m
10. Connect the generator connectors L and S.
11. Connect a wire to the terminals of the generator.
12. Secure the nut at terminal B.
13. Close the terminal in the generator protective cap.
14. Install the air inlet and fix its collar.
15. Install the intake of fresh air.
16. Replace the front bolts intake of fresh air.
17. Connect the cable to the negative terminal of the battery.

A warning

Make sure the battery cables are correctly connected.

Do not use high-voltage devices, such as a megohmmeter to check for resistance.

Remember that the battery voltage is always applied to the terminals of the alternator.

Do not connect to "weight" contact L, with the engine running.

Do not start the engine, while the contacts L and S are disconnected from the generator.

« previos page
Alternator drive belt

next page »
Repair the generator