REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Sephia / Shuma (1995 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Sephia / Shuma
		Maintenance
		Engine
		Greasing system
		Cooling
		The power supply system and release
		Fuel system
		Ignition system
		Coupling
		Manual transmission
		Automatic Transmission
		Axes and power shafts
			Technical data
			Checking the bearing play of the front wheels
			Checking the status of the drive shaft
			A rotary fist and a nave of a forward wheel
			Rear axle
			Drive shaft
			Repair knuckle
			SHRUS type Tripoid
		Steering
		Wheels and tires
		Brakes
		Suspension
		Body
		The air conditioning system
		Electrical equipment

Rear axle

Rear axle

1 - wheel;
2 - dust cap;
3 - a counternut to (replace);
4 - a brake drum (or disc);

5 - a nave with the bearing;
6 - Rear brake;
7 - axis;
8 - the parking brake cable

Withdrawal

PERFORMANCE ORDER

1. Lift the car and fix on support.
2. Remove the four wheel nuts.
3. Remove the wheel.
4. Remove the dust cap, unbend a fillet and remove the lock nut and the two mounting bolts of the brake drum.
5. Remove the brake drum (or disc) from the rear brake.
6. Remove the hub bearing.
A warning After disconnecting the brake pipe, close it with a suitable plug to prevent leakage of brake fluid.
	7. Special key OK130 430 019 turn away a connecting nut of a brake tube.
8. Remove the two screws and remove the rear brake.
9. Remove the two lateral traction and trailing arm from the support of a back nave.
10. Loosen and then remove the two screws on the rear strut to the support hub.
11. Remove the bearing hub of the rear strut.
12. Check the condition of all details and, if necessary, repair or replace the damaged parts.

Setting

PERFORMANCE ORDER

1. Establish a support hub in the rear strut and fix two bolts and nuts. Torque: 93-116 N ??? m
2. Install two transverse traction on the support of a nave and fix a bolt and nut. Torque: 93-116 N ??? m
3. Install the trailing arm on the support of a nave and fix a bolt. Torque: 43-61 N ??? m
4. Install the rear brake, and secure with four bolts. Torque: 45-67 N ??? m
	5. Special key OK130 430 019 tighten the coupling nut of a brake tube. Torque: 13-18 N ??? m
6. Install the hub bearing.
7. Install the brake drum (or disc) to the rear brake and fix two bolts. Torque: 9,8-15 N ??? m
	8. Screw a new nut with a fillet and hammer in a nut fillet into a nave groove. Torque: 210-279 N ??? m
9. Install the wheel.
10. Tighten the wheel nuts. Torque: 88-118 N ??? m
12. Lower the car.
13. Check the angles of the rear wheels.

next page »
Drive shaft