add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Sephia / Shuma (1995 release)
general info. full specifications. diagnostics. hints. tips. tricks
 Kia Sephia / Shuma
Home
 
Kia
Sephia / Shuma
Maintenance
Engine
Greasing system
Cooling
The power supply system and release
Fuel system
Ignition system
Coupling
Manual transmission
Automatic Transmission
Axes and power shafts
Steering
Technical data
Check of a steering without the amplifier
Check steering with hydraulic booster
Belt drive power steering pump
Replacement of a protective cover of steering draft
The steering shaft
Steering transfer
Power steering pump
Repairing the steering shaft
Repair of steering transfer
Repair of power steering pump
Wheels and tires
Brakes
Suspension
Body
The air conditioning system
Electrical equipment
 


Hit Counter by Digits


print page printable version

The steering shaft



The steering shaft

1 - driver airbag;
2 - lock nut;
3 - the steering wheel;
4 - column cover;
5 - coil spring;
6 - combination switch;
7 - the bottom casing;
8 - mounting plate;
9 - dust cover;
10 - coupling bolt;
11 - the steering wheel lock;
12 - steering column assembly;
13 - the universal joint;
14 - an intermediate shaft

Withdrawal

PERFORMANCE ORDER
1. Disconnect the negative battery terminal.
2. Place the front wheels straight.
3. Remove the four screws and remove the airbag from the steering wheel.
4. Disconnect an electric socket from the switch of a sound signal.
5. Put combination labels on a steering shaft and steering wheel to the right to be reinstalled.
6. Remove the retaining nut and remove the snap ring from the end of the steering shaft.
7. A stripper, remove a steering wheel.
A warning

Do not remove the steering wheel, hitting the hammer shaft end. This will lead to damage to the bearings and the shaft thread.

8. Remove the three screws and remove the bottom of the column cover.
9. Remove the three screws that secure the combination switch.

10. Disconnect an electric socket of the combination switch.

11. Moving on the steering column, remove the combination switch.
12. Disconnect the electrical connector from the ignition.
13. Remove the screw securing the ignition.
14. Remove the ignition.
15. Remove the two clamping screws on the universal joint.
16. Remove the bottom two nuts steering column bracket.
17. Remove the two screws on the upper steering column bracket.
18. Remove the steering column of the vehicle.

Setting

PERFORMANCE ORDER
1. Place the steering column into the vehicle.
2. Replace the bottom two nuts steering column bracket.
3. Replace the two screws on the upper steering column bracket.

Torque:
Nuts: 16-23 N ??? m
Bolts: 16-23 N ??? m

4. Replace the two clamping screws on the universal joint.

Torque: 18-26 N ??? m

5. Turn the ignition switch.
6. Connect to the ignition switch electrical connector.
7. Connect the switch to a combined electric socket.
8. Set the combination switch on the steering column.
9. Install the upper and lower casings of a steering column.
10. Screw in the three screws that secure the column cover.
11. Connect the connectors and install the coil spring on the shaft of the steering column.
12. According to earlier put labels establish a steering wheel.
13. Install the snap ring and screw lock nut.

Torque: 39-49 N ??? m

14. Connect the electrical connector sound.
15. Establish a safety pillow.
16. Connect the cable to the negative terminal of the battery.




« previos page
Replacement of a protective cover of steering draft		 next page »
Steering transfer

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.