| 1. Remove the front wheels. |
| 2. Remove the cross member below the engine compartment. |
| 3. Remove the bracket gearbox. |
| 4. Disconnect the connection of the oxygen sensor. |
| 5. Disconnect the exhaust pipe from the exhaust manifold. |
| 6. Disconnect draft from the gearbox. |
 | 7. Remove the connecting rods from the rod stabilizer bar. |
 | 8. Remove the mounting rod stabilizer bar. |
| 9. Establish a jack under a cross-beam front suspension, remove the four mounting screws and two nuts and lower cross member. |
| 10. Remove the stabilizer bar from the vehicle. |
| 11. Check the condition of plugs of fastenings and spherical hinges of connecting rods. Replace worn elements. |
12. Installation is spent upside-down removals. |
