| 1. Remove the rear wheels. |
| Wishbones |
| Front lever |
 | 2. Unscrew and remove the through bolt (arrow) securing the arms to the bracket hub. |
| 3. Remove the plugs from the rear suspension crossmember. |
 | 4. Remove the nuts inner ends wishbone (indicated by arrows). |
| 5. Mark the installation position of the cross in the bottom of the car. |
| 6. Establish a jack under a cross-beam, turn off fixing bolts and lower cross member. Remove the inner hinge pins and remove the control arm. |
| 7. Installation is spent upside-down removals. |
| The rear arms |
| 8. Remove the tie-rod stabilizer bar on the rear arm. |
| 9. Remove the through-bolts securing the outer ends of the wishbone to the bracket hub. |
 | 10. Mark the installation position of the adjusting cams. Remove the inner mounting nut and remove the rear wishbone suspension. |
| 11. Installation is spent upside-down removals. |
| Trailing Arm |
| 12. Remove the cable hand brake control arm. |
 | 13. Remove the bolt of the lever arm to the hub. |
 | 14. Remove the hinge pin and remove the trailing arm. |
| 15. Installation is spent upside-down removals. |
|
