 printable version
general information
Signaling device lighting and interior lighting symbols: check their functioning. Check outdoor lights, if necessary, adjust the headlights. Check the audio signal. Check for wear on the rubber wiper blades. Washer: check operation, check the position of the nozzle, check the headlamp washers. Check the adjustment of the optical axis angle of headlights. All current users: check their functioning. Replace the rubber wiper blades windshield. Rubber wiper blades range: check the condition. Clean the telescopic rod antenna. Check the functioning of sensors / outdoor lighting SWITCHES | PERFORMANCE ORDER | | 1. Turn on the ignition (turn the ignition key to the "2"). | | 2. Light the alarm for about 30 seconds and then extinguish. Check whether all the lamps light up according to the vehicle's equipment. | | 3. Alarm system installation and tensioning of seat belts (air bag) should be extinguished no later than about 4 seconds. | | 4. Turn on the main beam, powered by a flashing warning lights and check the alarm. |
|
OUTDOOR LIGHTING | PERFORMANCE ORDER | | 1. Check for damage and water penetration glass sensors front and rear lighting. | | 2. Turn on outside lights and check its operation. |
|
Checking control angle of the optical axis of headlights | PERFORMANCE ORDER | | 1. Start the engine and let it run at idle. | | 2. Turn on the dipped beam. | | 3. Place the controller in different positions (offset) the angle of the optical axis of the headlights and checks to see if the two light-beam headlamps simultaneously. |
|
Cleaning the telescopic rod antenna The necessary wearing parts: cleaning cloth fabric to the telescopic antenna. | PERFORMANCE ORDER | | 1. Pull out the antenna or pull it, turned on the radio. | | 2. Clean the telescopic rod cleaning cloth fabric. | | 3. Push the antenna or by switching off the receiver automatically make her recede. | | 4. This operation is repeated several times. | | 5. Then dry with a telescopic rod with a clean cloth. |
|
| 
