REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz C-Class (from 1993 to 2000, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	C-class
		Introduction
		Maintenance
		Engines
		Lubrication system
		Cooling
		Heating and ventilation
		Ignition system
		Fuel system
		Chassis
		Steering
		Brakes
		Body
		Electrical
			Electrical system
				Introduction
				Measuring devices
				Measurement Equipment
				Electrical Inspections
				Sound signal
				Replacement fuses
				Accumulator battery
				Generator
				Starter
				The traction relay
				Lighting system
				Devices
				Dashboard
				Incandescent lamps on the instrument panel
				Light switch
				Radio
				Antenna
					Telescope automatic antenna
				Speakers
				Rubber wiper blades
				Windshield washer jets
				Cleaning nozzle range
				Wipers and its engine
				Defend your own car
				Anti-theft "immunodeficiency"
				Why dim lights
				"Galogenki"
			Wiring

printable version

Antenna

77, 78. Bolts

79. The upper part of the seal

80. The lower part of the seal

81. High Wire

82. Electrical connector

M11. Automatic antenna

Withdrawal

PERFORMANCE ORDER

1. Disconnect from the terminals of the battery ground cable (-).

A warning

This erased anti-theft radio code. Before disconnecting the wires see. Recommendations subsection 14.1.7.

2. Open the boot lid, release the clip and remove the side trim.

3. Remove the wire for connecting the housing with the bolt (77).

4. Remove the antenna at the bottom of the holder (78) and remove it from the bottom of the rubber bushings in the wing. Unplug the antenna wire from the terminals (81) and, if present, the control line (82).

Setting

PERFORMANCE ORDER

1. Check the rubber grommet in the wing of the absence of porosity or damage, replace it if necessary.

2. Enter the antenna from the bottom and insert the spherical head to the bottom of the sleeve.

3. Push the upper part of the sleeve and secure it at the bottom.

4. Screw the antenna to the holder.

5. Screw on the body wire to connect the antenna to the car body.

6. Attach the antenna wire to the terminal. If you have an antenna with a remote control connected to the terminal electric control line.

7. Push and secure the spring clamps the side trim.

8. Connect the terminal of the battery ground cable (-). Set the clock and program the anti-theft code for the radio.

« previos page
Radio

next page »
Telescope automatic antenna