| 1. Open the hatch on 3/4. |
| 2. Unhook the spring clips on the front trim panel sun roof body. |
| 3. Fully open the hatch. |
| 4. Remove the top casing of the hatch. |
 | 5. Remove the Phillips screws (arrows) and remove the guide bar. |
| 6. Close the door. |
 | 7. Remove the left and right nuts (arrows). |
| 8. Remove the top hatch. |
| 9. Blow pressurized air weir top left and top right. |
| 10. Check the floating pads for damage and replace them if necessary. |
| 11. Clean the floating pads and lubricate anti-friction paste. |
| 12. Clean the guide rails, grease a working surface. |
 | 13. Insert the dowel screws (arrow) on the left and right of the centering hole. |
| 14. Insert the top hatch. Fit the nuts without tightening them tight. |
 | 15. With the illustration of special pre-mites hold hatch and then tighten the nut. |
| 16. Open the door. |
| 17. Screw the guide bar. |
| 18. Insert and secure the spring clamps trim hatch. |
