CAUSE | REMEDY |
Clutch twitches |
| Too low engine speed at idle | Check the control engine speed at idle. |
| Bearing failure of the motor shaft and the bearing shaft of a transmission | Check and replace if necessary. |
| Uneven adjacent pressure plate | Replace the pressure plate. |
| No firm disk clutch | Set firm disk clutch. |
Clutch slips |
| Worn clutch disc | Check the thickness of the clutch disc, if necessary, replace the clutch disc. |
| Faulty clutch pedal limit stop | Check the limit stop clutch pedal. |
| Too low tension diaphragm spring | Replace the pressure plate. |
| Seized distribution cylinder | Replace the distribution cylinder. |
| Leaking cylinder distribution | Perform a visual inspection. |
| Friction lining hardened and zamaslilas | Replace the clutch disc, remove the cause of contamination. |
| Clutch was overheated | Install the genuine parts. |
Wrong clutch is released |
| Sensor leaking cylinder | Check sensor-cylinder charge push the pedal and check whether the liquid is boiled in the receiver. |
| The air in the clutch system | Bleed the clutch operation. |
| The clutch pedal does not reach the limit stop | Check the limit stop clutch pedal, if necessary, cut a rug. |
| Sticky friction lining due to abrasion | Replace clutch disc. |
| Clutch Disc seizes the primary transmission melkoshlitsevoe compound or dried sticks | Clean melkoshlitsevoe compound, remove any burrs, if necessary, remove rust. |
| The disc clutch has a lateral runout | Instructed to check the clutch disc and replace if necessary. |
| Faulty centering bearing of a primary shaft of a transmission on the crankshaft | Replace guide bearing on the crankshaft. |
| Fix rotation of the bearing sleeve or the clutch pedal hard | Replace clutch bearing clutch pedal must be squeezed out easily. |
The clutch pedal is not returned or is returned back to the slowdown |
| The air in the clutch system | Bleed the clutch operation. |
| Old (oxides) brake fluid | Replace brake fluid. |
| Seized distribution cylinder or sensor | Replace the distribution cylinder or sensor. |
| Worn clutch disc | Replace clutch disc. |
| Because of overheating damaged clutch pressure plate, which is why it has weakened the force reset | Replace the pressure plate. |
Noise in the clutch pedal is depressed |
| Faulty clutch bearing clutch | Check the clutch bearing clutch and replace if necessary. |
| The disc clutch has a pressure plate | Replace clutch disc. |
Increasing noise and sagging push or pull, or if the vehicle rolls when the clutch |
| Difficult course of the torsional vibration damper clutch | Restore the clutch disc or replace it. |
| Riveted joints loose coupling | Replace clutch. |
| Too much imbalance clutch | Replace the clutch and clutch disc. |
