REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz E-Class W123 (from 1976 to 1985, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	W123
		Introduction
		Gasoline engines
			Design and specifications
			Engine adjustment
			Ignition system
			Power system
				The power supply system with the carburettor Stromberg
				The power supply system with a carburetor Solex 4A1
					Adjusting the engine idling
					Clean the carburetor
					Removal and installation of the carburetor
					Replacement of the needle valve and setting the fuel level in the float chamber
					Check and adjust the automatic starting arrangement
					Adjusting the throttle actuator 1st camera
					Check additional trigger device
					Check and adjust the accelerator pump
					Check solenoid shut-off valves
					Removal and installation of the case of a bimetallic spring automatic starting device
					Removal and installation of the fuel pump
			The fuel injection system K-Jetronic
			The fuel injection system L-Jetronic
			Works by car
			Work on the engine M 102
			Work on the engine M 110 and M 123
		Coupling
		Manual transmission
		Automatic Transmission
		Driveline and rear axle
		The front suspension
		Rear suspension
		A steering
		Brakes
		Electrical
		Body and Equipment

printable version

Adjusting the throttle actuator 1st camera

Adjusting the throttle actuator 1st camera

A - the gap between the throttle control and the adjustment screw amount of a mix of idling
F - the length of the spring between the actuator nuts
1 - the adjusting screw amount of a mix of idling
2 - the lever throttle
3 - a nut
4 - lock nut
5 - a nut of adjusting the length of the spring actuator

PERFORMANCE ORDER
Check the gap "A" between the amount of the adjustment screw 1 mixture of idling and throttle control, which should be within the range 3.0 ?± 0.2 mm.
If necessary Achieve proper size nut 3 after loosening the lock nut 4.
Check the length of the ?«F?» spring actuator between the nuts, which must be equal to 23 mm. If necessary Achieve proper size nut 5.

« previos page
Check and adjust the automatic starting arrangement

next page »
Check additional trigger device