REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Sunny (from 1991 to 1997, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Nissan
	Sunny
		Instructions
		Maintenance
		Engines
		Cooling
		Heating and ventilation system
		Fuel and exhaust system
			Carbureted engines
			Engines with fuel injection system
				Technical data
				Air filter
				The accelerator cable
				Throttle pedal
				Fuel
				Fuel Injection System
				Decompression of the fuel system
				Fuel pump
				Fuel Level Sensor
				Fuel tank
				Fuel Injection System
				Throttle Body
				Units of the fuel injection system
					The fuel distributor and nozzles
					Pressure regulator
					Throttle Sensor
					The bypass damper
					Velocimeter
					Valve correction idle when the load on the engine
					Thermostat increased idle speed
					Crank angle sensor and the transistor module
					Coolant temperature
					Processing Unit
					Switch neutral PPC
					Starter switch and signal reversing
					The fuel pump relay and control unit
					Override switch idling at work power steering
					Override switch idling when the air conditioner
					Vehicle Speed Sensor
				Suction collector
				An exhaust manifold
				Exhaust system
			The power supply / exhaust
			Emission of exhaust gases
		The system of the engine is started
		Coupling
		Transmissions
		Axles
		Brakes
		Suspension and steering
		Body
		Electrical

Throttle Sensor

Location Sensor

Angle sensor (variable resistor) is mounted on the right side of the valve body.

Refitting

PERFORMANCE ORDER

1. Disconnect the battery from weight.
2. Disconnect the connector.
3. Apply the label sensor orientation relative to the housing.
4. Remove the two screws and remove the gauge.
5. When assembling, make sure that the lever of the sensor has come into engagement with the throttle lever.
6. Align the labeling and slightly tighten the screws.
7. Set the sensor so that its resistance to conform to the standards.
8. Tighten the screws of the sensor and attach the connector.
9. Connect the battery to weight.