| 1. Hold down the bottom of the rack in a vice through the pads. |
| 2. Screw the nuts onto the studs, leaning into the hairpin arm, release the upper shock absorber rod nut. Completely nut does not turn away. |
| 3. Compress the spring with special tool so that the top plate can be rotated by hand. |
| 4. Remove the stem nut, hold the stem from turning. |
| 5. Remove the washer, gasket, the top cap and spring plate. |
| 6. Remove the spring, dust cover and a rubber buffer. |
| 7. Check the details, worn or damaged parts, replace. |
| 8. Check for leaks from the shock absorber and the state of the stock over the whole length. |
| 9. Check for cracks on the body and damage. |
| 10. Check the rack, first put forward the entire length of the stem, and then vdvigaya and pushing rod 50-100 mm. It should feel smooth resistance to movement of the rod. |
| 11. If there are signs of leakage, mechanical damage, and movement of the rod is accompanied by a "choppy", the desk must be replaced. Springs and all parts can be mounted on a new stand. |
| 12. Inspect the spring. |
| 13. If found severe corrosion of springs, cracks in the turns, deformation, or any signs of questionable condition, replace the spring. |
| 14. Clamp the rack in a vice and install the rubber buffer and the dust cover. |
| 15. Squeeze and install a spring so that the color marking facing down. End coil spring should go to deepening the plate. |
 | |
| 16. Install the upper plate of the buffer and properly positioning the coil springs at the plate. Installation rack arrow at the top plate should be turned laterally outward (A - transverse direction - toward the front). |
| 17. Assemble the upper strut, respecting the order details, and tighten the new stem nut. |
| 18. Tighten the nut to the specified torque while holding the rod. |
| 19. Remove the adaptation for spring compression. |
