| 1. Disconnect the battery from weight. |
| 2. Remove the inner door panel (see. Subpart 13.11). |
| 3. Disconnect all connectors, mark the route of the wiring and remove the brackets. |
| 4. Carefully pull the wiring of the door opening, pulling seals. |
 | 5. Knock-axis limiter door opening. |
| 6. Mark the position of the hinges on the door. |
 | 7. While supporting the door, unscrew the hinge screws and remove the door. |
| 8. Check the condition of the loop, if necessary, replace by removing the screws on the body. |
| 9. Flap Clutch. |
| 10. Lower the clutch housing bolts to the engine block. |
| 11. The door is installed in reverse order of labeling. Replace the axis of the stopper. If necessary, adjust the door. |
