| Castle |
| 1. Disconnect the battery from weight. |
| 2. Remove the inner cover panel. |
| 3. Disconnect from the lock actuator rod. |
| 4. Disconnect the light switch connector trunk. |
| 5. Remove the two screws and remove the lock through the opening in the lid. |
| 6. Install the lock in reverse, having tracked correctness of installation rods. |
| Switch the cargo compartment lid lock |
| 1. Disconnect the battery from weight and remove the inner cover panel. |
| 2. Remove the four screws that secure the plates to the handle inside. |
| 3. Remove the nut and release the latch plates. |
| 4. Disconnect sign lighting. |
| 5. Disconnect draft from the outside handle, remove the cover plate on the outside of the lid, remove the sealing wire mark of the holes in the lid. |
| 6. Disconnect draft from the lock cover. |
 | 7. Remove the two nuts (arrows) and remove the lock switch on the outside of the lid. Remove the gasket. |
| 8. Turn the lock backwards. Replace the gasket, check the connection rods, check the operation of the lock. |
| Lock striker |
| 1. Remove the latch and remove the back cover of the cargo hold. |
| 2. Remove the two screws and remove the retainer. |
| 3. Set the lock backwards. |
| Outdoor handle cargo compartment |
| 1. Disconnect the battery from weight and remove the inner cover panel. |
| 2. Remove the four screws that secure the plates to the handle inside. |
| 3. Remove the nut and release the latch plates. |
| 4. Remove the two screws and remove the handle. |
| 5. Set the handle in reverse order. Check the connection rods, check the operation of the lock. |
