| The glovebox |
| 1. Remove the bottom two screws and remove the box. |
| 2. Assemble in the reverse order. |
| The lower section of the front of the driver's side |
| 3. Remove the screws at the top and bottom edges and remove the section from the front panel. |
| 4. Assemble in reverse order. |
| The middle part of the front panel pushbutton switches |
| 5. Disconnect the battery from weight. |
| 6. Remove the cover from the gear lever |
| 7. Remove the screws on both sides of the panel, gently slide it forward. |
| 8. Disconnect switch and remove the panel. |
| 9. If necessary, mark the route bundles to the assembly to lay the wiring in place. |
| 10. The assembly is performed in reverse order. Make sure that the air vents into the corresponding air ducts. |
| Facing the steering column |
| 11. Disconnect the battery from weight. |
 | |
| 12. Remove the bottom 6 screws, remove the bottom cover of the ignition switch (left) and post down, disconnected from the upper latch plates (pictured right). |
| 13. Turn both levers all the way down and gently remove the top cover. |
| 14. The assembly is performed in reverse order. |
| Cover instrument panel with air vents |
| 15. Remove the steering column covers. |
| 16. Remove the two upper bolts and slightly tilt column. |
 | |
| 17. Remove the screws decorative casing dashboard (two on the left, two on the right and one at the bottom (right) and one at the top (left)). |
 | 18. Carefully remove the cover from the front panel. If you want to post a column down to the expansion of space. |
| 19. The assembly is performed in reverse order. Upper column bolts tighten with the set moment. |
