| 1. Install the valve guide sleeve, after brushing it with engine oil. |
| 2. Install the valve spring thrust washer 4 (see. Fig. Camshaft and valves). |
| 3. Push the valve stem on the plastic sleeve so as not to damage the lip of the valve stem cap. |
| 4. Have a special tool valve stem seal 5. Remove the valve stem with a plastic sleeve. |
| 5. Install the valve spring 6 and 7 of the spring plate. |
| 6. The special adaptation to compress the valve spring and replace crackers 8. Remove the tool to compress the valve springs. Hit the hammer with a soft head on the end of the valve stem to crackers properly into place. |
| 7. Similarly, the other set valves. |
| 8. Coat the engine oil cervical camshaft 12, and gently insert the shaft into the head unit. |
| 9. Press in the oil seal camshaft mandrel. |
| 10. Install plate 16 (see. Fig. The ignition distributor) with a gasket 17. Tighten the screws 18 to 20 Nm (2.0 kgf-m). |
| 11. Insert the key into the groove of a cam 13 (see. Fig. Camshaft and valves), to establish a cogwheel 14. Tighten bolt 17 with a washer 18 and tighten the bolt to 80 Nm (8.0 kgf-m). |
| 12. Install the adjusting screws 9. |
| 13. Install the valve lever 10 and spring 11. |
| 14. To establish the ignition distributor. |
| 15. Install the fuel pump. |
