REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Golf II, Jetta (from 1983 to 1992, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Golf 2 / Jetta
		General Information
		Engine
		The power supply system
		Coupling
		Transmission
		Transmission
		Front-wheel Drive
		A steering
		Suspension
			Front suspension
				Specifications
				Strut
				Rounded fist
				Wheel Bearing
				Arm front suspension
				Anti-roll bar
				Adjustment of corners of installation of forward wheels
				Check alignment of the rear wheels
			Rear suspension
		Brakes
		Body
		Electrical

Wheel Bearing

A warning

If the bearing understood, then re-install it impossible. Bearings must be replaced.

Withdrawal

PERFORMANCE ORDER

1. Remove the knuckle (see. Subsection 9.1.3).

2. Drive out of the knuckle 27 (see. Fig. The front suspension), the wheel hub.

3. Compress the inner ring of the bearing from the hub.

4. Remove the retaining rings 29 and 34.

5. Press off the outer ring of the bearing from the knuckle 27.

Setting

PERFORMANCE ORDER

1. Clean the bearing seat of the old grease and apply a new universal grease while the bearing itself is not lubricated.

2. Install the retaining ring 34 in the knuckle 27.

3. Press in the new bearing in the knuckle 27 by applying a force to the outer ring of the bearing.

4. Install the retaining ring 29 in the knuckle 27.

5. Press on the hub wheel bearing 35 with a rotary fist by applying a force to the inner ring of the bearing.

6. Install the steering knuckle (see. Subsection 9.1.3).

7. Lift the front of the car again.

8. Check the bearing by turning a wheel which should rotate without jamming and large cross play.

« previos page
Rounded fist