REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Golf IV (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Golf 4
		Instructions
		Engine
		Cooling system
		Fuel System
		Exhaust system
		Ventilation and heating system
		Coupling
		Transmission
		Suspension brackets and power shafts
		Steering
		Wheels and tires
		Brakes
		Body
			Care body
			Care of an upholstery and rugs
			Repair of insignificant damages of a body
			Repair of strong damages of a body
			The front body panel
			Removing and installing front bumper
			Removing and installing rear bumper
			Removal and installation of a forward wing
			Removal and installation of facing of a niche of a forward wing
			Removal and installation of facing of a niche of the rear wing
			Hood
				Withdrawal
				Setting
				Adjusting the hood
			Hood lock
			Removing and installing radiator grille
			Removal and installation of a lateral overlay of a body
			Door
			Luke
			Purification gutter
			Mirrors
			The center console
			Removal and installation of the top furnish in space for feet of the driver
			Removal and installation of the glove compartment
			Removal and installation of a lateral covering of space for feet
			Removal and installation of overlays of thresholds
			Removal and installation of the bottom facing of the central rack
			Removal and installation of the right lateral covering of a luggage space
			Removing and installing luggage compartment floor coverings
			Removal and installation of back furnish of a luggage space
			Removing and installing front seat
			Side airbags
			Removing the rear bench seat cushion
			Removing and installing rear seat backrest
			Washers and wipers
		Electrical equipment and wiring

Adjusting the hood

PERFORMANCE ORDER

	1. Unscrew the screws (indicated by arrows), fastening a lock (1) of the hood.
2. Close the hood and check its location relative to adjacent surfaces.
3. Adjust the position of the hood so that when the hood is closed the gap on the perimeter of the hood was the same from all sides.
4. To adjust, loosen the bolts and hinges of the hood by moving the hood, adjust its position.
5. After the adjustment, tighten the bonnet hinge bolts to 20 Nm.
6. Adjust the height of installation of the hood by turning the rubber buffer (2) (see. Fig. Elements of fastening of the hood).
7. Tighten the lock of a cowl 20 Nm.

« previos page
Setting

next page »
Hood lock