REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Golf IV (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Golf 4
		Instructions
		Engine
		Cooling system
		Fuel System
		Exhaust system
		Ventilation and heating system
		Coupling
		Transmission
		Suspension brackets and power shafts
		Steering
		Wheels and tires
		Brakes
		Body
			Care body
			Care of an upholstery and rugs
			Repair of insignificant damages of a body
			Repair of strong damages of a body
			The front body panel
			Removing and installing front bumper
			Removing and installing rear bumper
			Removal and installation of a forward wing
			Removal and installation of facing of a niche of a forward wing
			Removal and installation of facing of a niche of the rear wing
			Hood
			Hood lock
			Removing and installing radiator grille
			Removal and installation of a lateral overlay of a body
			Door
			Luke
			Purification gutter
			Mirrors
			The center console
			Removal and installation of the top furnish in space for feet of the driver
			Removal and installation of the glove compartment
			Removal and installation of a lateral covering of space for feet
			Removal and installation of overlays of thresholds
			Removal and installation of the bottom facing of the central rack
			Removal and installation of the right lateral covering of a luggage space
			Removing and installing luggage compartment floor coverings
			Removal and installation of back furnish of a luggage space
			Removing and installing front seat
			Side airbags
			Removing the rear bench seat cushion
			Removing and installing rear seat backrest
			Washers and wipers
				Replacement of rubber tapes of brushes of screen wipers
				Adjusting windscreen washer nozzles
				Removal and installation of windshield washer nozzles
				Removing and installing rear window washer nozzles
				Removing and installing wiper arms
				Removing and installing windscreen wiper motor
				Removal and installation of tanks and washer pump
				Removing and installing rear window wiper motor
		Electrical equipment and wiring

printable version

Removing and installing wiper arms

Withdrawal

PERFORMANCE ORDER

1. Wet the windshield with water, then turn on and turn off the wiper so that the wiper arm established in a starting position.
2. Remove a wire of weight from the accumulator.
3. Remove the wiper blade.
	4. Using a thin blade screwdriver, remove the cover at the base of the wiper arm (location casings indicated by arrows).
5. On some turns unscrew the wiper arm nuts.
6. Move the wiper arm to the side, loosen it landed on the line, then unscrew the nut and remove the wiper arm.

The initial position of the windscreen wiper blades

A, B = 20 + 10 mm

Setting

PERFORMANCE ORDER

1. Install the wiper arm in such a position that the windshield wiper blade located at a distance of 20 ?± 10 mm from the base of the windshield.

2. Secure the wiper arm nut, tightening it to 20 Nm.

3. Install the decorative caps on the wiper arm nuts.

« previos page
Removing and installing rear window washer nozzles

next page »
Removing and installing windscreen wiper motor