printable version

Replacement silencing

Place disconnecting pipes of the exhaust system on front wheel drive cars with four- and five-cylinder engines except for engines 150 hp. from.

A = 140-150 mm

A = 160-170 mm for the five-cylinder engine. A = 160-180 mm for turbocharged engines.

A = 244 mm

If disconnection of pipes of the exhaust system is difficult, use one of the following method:

- Cut the exhaust pipe at a distance of 5 cm for the mounting bracket. Saw along the axis of the remaining length of the pipe and bring down his hammer and chisel using;
- Using autogenous welding machine, heat the pipe joint and disconnect the tube.

Lift the car and fix on supports.

Front-wheel drive vehicles with four- and five-cylinder engines except for engines 150 hp. from.

Place disconnecting pipes of the exhaust system is located 140-150 mm from the central silencer, see. Fig. Place disconnecting pipes of the exhaust system on front wheel drive cars with four- and five-cylinder engines except for engines 150 hp.

Front-wheel drive cars with engines of 150 hp. from.

Place disconnecting pipes of the exhaust system is located to the additional muffler on models with five-cylinder engine of 160-170 mm, and turbocharged engines 1,8-I of about 160-180 mm. See Fig. Place disconnecting pipes of the exhaust system on vehicles with front-wheel drive motor 150 liters.

All-wheel drive vehicles and vehicles with engine 6V

Place disconnecting pipes of the exhaust system is at a distance of 244 mm from the central silencer, see. Fig. Place disconnecting pipes of the exhaust system on the four-wheel drive cars and vehicles with engine 6V.

In this place, cut the pipe exhaust system.

Release silencer from rubber suspension and remove it from under the car.

Setting

PERFORMANCE ORDER

1. Place the rubber muffler hangers. 2. To connect the pipes of the exhaust system must use the new clamping bracket. 3. Check the muffler and, if necessary, turn it so that the distance between the silencer and the bottom of the car was not less than 25 mm. 4. Tighten the nuts clamping bracket 40 Nm.