|  printable version
 Removing and installing sump
 
   Pan may be removed from the engine mounted on the vehicle.  Removing the oil pan is conducted in the following order:  
 |  |   Fig.  166. Lubrication System 2.0-liter engine: 1 - installation and replace it with a new one;  2 - oil filler cap;  3 - the dipstick to check the oil level;  4 - guide tube probe to check the oil level;  5 - the oil pressure switch to 25 kPa;  6 - oil pressure switch 180 kPa;  7 - return valve 5 Nm;  8 - the plug;  9 - nut 25 Nm;  10 - the base of the oil filter;  11 - O-shaped sealing ring is always substitution;  12 - oil cooler;  13 - the oil filter;  14 - a gear wheel of the oil pump;  15 - a cover of the oil pump with pressure relief valve;  16 - bolt 10 Nm;  17 - bolt 20 Nm;  18 - a bolt of fastening of the oil sump;  19 - O-ring, replace;  20 - the plug to drain the oil;  21 - oil pan;  22 - installation and replace it with a new one;  23 - oil receiver;  24 - the oil guide plate;  25 - installation and replace it with a new  
 
 
 | 
 
   - Unscrew the plug 20 (see. Fig. 166)  the oil drain and drain the engine oil from the engine into the prepared container; 
 |   Note    Dispose of the old engine oil must be in compliance with environmental regulations.  | 
   - Remove the protection crankcase;    - Remove the bolts 18 fastening and remove the oil pan 21 with the gasket 22.  
 |   Note    On the 2.0-liter engine is hard to get to the oil pan mounting bolts located on the flywheel side.  On STO for this are special keys for the bolts 3249 and 3185.  | 
   Install sump spend to sequences, return to removal, thus observe the following points:    - The old gasket pallet always replace a new one.  Make sure the gasket is not moved during the installation;    - Before installing apply to the contact surface of the oil pan and cylinder block sealing ?«D2?»;    - Crosswise tighten the screws of the oil pan.  Hex bolts are tightened to 20 Nm (2.0 liter engine) and torque of 15 Nm (engine VR6);    - Pour in the engine of 5.5 liters of engine oil, oil filter if the shot;    - If the oil filter is not removed, then fill it with 5.0 liters of oil.  
 
 
 
 
 |