CAUSE | SOLUTION |
Starter does not rotate when you turn the ignition |
| Discharged battery | Charge the battery |
| Connect terminals 30 and 50: the starter works. Interruption in the wire 50 to the ignition, defective ignition switch | Repair the open. Defective parts replaced |
| Broken cable or poor connection to its mass. The battery is discharged | Check battery cables and connections. Measure the voltage of the battery when you need to charge |
| Insufficient current strength because of the weakening of contacts or oxidation | Clean poles and terminals of the battery. Restore the reliability of connections between the battery, starter and weight |
| No voltage at terminal 50 (magnetic switch) | Broken wire. Faulty ignition switch |
Starter turns too slowly and scrolls engine |
The battery is discharged
| Charge the battery |
| The engine is not flooded with winter or all-season oil (winter) | Change oil |
| Insufficient current conductivity due to the weakening of contacts or oxidation | Clean connection terminals and pole starter. Tighten connections |
| Graphite brushes do not adjoin to a collector, jammed in the guides are worn, broken or contaminated zamaslyany | Check, clean or replace the graphite brushes. Check rails |
| Inadequate distance between the collector and the graphitic brushes | Replace graphite brush and clean their guides |
| Furrows on the collector, soot or dirt | Pierce a collector or replace an anchor |
| No voltage at terminal 50 (not less than 8V) | Check the ignition switch or a magnetic switch |
| Split bearing | Check, if necessary, replace bearings |
| Faulty magnetic switch | Replace relay |
The starter is activated and rotates the motor does not rotate or rotates intermittently |
| Faulty drive gear | Replace the drive pinion |
| Gear contaminated | Clean gear |
| Faulty flywheel | Process a gear wreath, if necessary, replace the flywheel |
It does not work the drive gear |
| Dirty drive gear. Screw thread is dirty or defective | Clean drive, replace if necessary
|
| Faulty magnetic switch | Replace magnetic switch |
| Loose or broken return spring | Replace the return spring |
The starter continues to rotate after the ignition is switched off |
| Switch magnetic switch hangs, will not turn off | Immediately turn off the ignition. Replace magnetic switch |
| The ignition switch is not turned off | Immediately disconnect the battery. Replace the ignition switch |
