add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Audi A6 (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks
Audi A6
Home
 
Audi
A6
General Information
Operation of the vehicle
Maintenance
Engines
Ignition, fuel injection and exhaust of gasoline engines
The power supply system, and preheating the exhaust gases of diesel engines
Lubrication System
Cooling system
Coupling
Transmission
The front wheel drive shafts
Design features four-wheel drive transmission
Overview
The propeller shaft
Adjusting the propeller shaft
Adjusting the position of the intermediate support propeller shaft
Adjust the axial position of the propeller shaft
Home reverse gear
The rear drive shafts
Differential main reverse gear
Suspension
Wheels and tires
Steering
Brakes
Body
Heating and air conditioning
Electrical
Electric schemes
 


Hit Counter by Digits


print page printable version

Adjusting the position of the intermediate support propeller shaft



If there is, remove the four screws and remove the crossmember beneath the exhaust pipe.
Remove the nuts securing the exhaust pipe connecting clamps, disconnect and remove the rear section of the exhaust system.

Location bolts thermofilter propeller shaft
Fig. 11.2. Location bolts thermofilter propeller shaft


Remove the bolt and thermofilter located above the propeller shaft (see. Fig. 11.2).
Fit the plastic nut on the propeller shaft of the device 3139, holding the propeller shaft of the deflection.
Remove the nuts and washers fastening intermediate support propeller shaft.

Setting intermediate support propeller shaft
Fig. 11.5. Setting intermediate support propeller shaft


Install the center bearing the PTO shaft so that the distance from the pole to the body as well (Fig. 11.5) was the same on both sides. Measure the distance and, depending on the distance to select the thickness of shims.
Install liner on both sides under the support of the propeller shaft.

The distance (a) mm
Lining Thickness, mm
0-3,0
-
3,1-5,0
2
5,1-7,0
4
7,1-9,0
6
9,1-11,0
8
11,1-13,0
10




« previos page
Adjusting the propeller shaft
next page »
Adjust the axial position of the propeller shaft

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.