add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Audi A6 (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks
Audi A6
Home
 
Audi
A6
General Information
Operation of the vehicle
Maintenance
Engines
Ignition, fuel injection and exhaust of gasoline engines
The power supply system, and preheating the exhaust gases of diesel engines
Lubrication System
Overview
Recommendations for use of motor oils
The oil pan and oil pump gasoline engine 1.8 liters
Sump gasoline engine 1.8 liters
Installing the oil pan
Oil pump gasoline engine 1.8 liters
The oil pan and oil pump petrol engines of 2.4 and 2.8 liters
The oil pan and the oil pump of the diesel engine of 1,9 l
The oil pan and the oil pump of the diesel engine of 2.5 liters
Cooling system
Coupling
Transmission
The front wheel drive shafts
Design features four-wheel drive transmission
Suspension
Wheels and tires
Steering
Brakes
Body
Heating and air conditioning
Electrical
Electric schemes
 


Hit Counter by Digits


print page printable version

Installing the oil pan



Install the oil pan in sequence, return to removal, taking into account the following.
Replace all seals and gaskets with new ones.
Installing the oil pan
with seal
Apply a small amount of sealant AMV 174 004 01 tabs front and rear sump.
Install the oil pan to the engine.

Installing the oil pan on the sealant
Plastic or wooden scraper to remove any sealant and old gasket mating surface of the engine.
With round metal brush, impaled on an electric drill, clean the sealant from the oil pan.

Place the sealant is applied to the gasket surface of the oil pan
Fig. 6.13. Place the sealant is applied to the gasket surface of the oil pan


Apply a bead of sealant D176 404 A2 2-3 mm in diameter on the surface of the oil pan gasket (Fig. 6.13).
After applying sealant sump must be installed for 5 min.
The layer of the sealant should have a diameter of less than 3 mm, as excess sealant may get into the oil and clog the mesh maslozabornik.

All models
Tighten the bolts in the following order:
- Tighten the screws 1-18 crosswise torque of 5 Nm;
- Tighten the oil pan to the transmission torque of 40 Nm;

Location and numbering (1-18) bolts to the engine oil pan
Fig. 6.12. Location and numbering (1-18) bolts to the engine oil pan


- Tighten the screws M10 (marked by arrows in Fig. 6.12) to 40 N ?� m;
- 1-18 tighten bolts crosswise to 10 Nm (M6) and 15 Nm (M7).
Set the sub-frame.

Cars with automatic transmission
Replace the pipes for oil cooling of an automatic transmission.

All models

Location bolts bearing reactive torque compensator
Fig. 6.5. Location bolts bearing reactive torque compensator


Establish a support compensator reactive torque on the rubber pad and fix bolts, having tightened their moment of 28 Nm (see. Fig. 6.5).
Install poly V-belt.
Install the fan with viscous coupling.
Fill the engine with engine oil.

Cars with automatic transmission
Check the oil level in an automatic transmission.




« previos page
Sump gasoline engine 1.8 liters
next page »
Oil pump gasoline engine 1.8 liters

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.