The degree of warning 2

The speed warning with a degree 2 can be adjusted only when the ignition is switched off.

Warning symbol with a degree 2 warning appears when the vehicle speed is exceeded with respect to a given speed and off, unlike much warning only 1 speed reduction below the programmed value.

The degree of warning 2 is recommended as a reminder to the driver on the limitation of a certain maximum speed, for example, when driving in the country, with a speed limit or a maximum operating speed of winter tires.

Programming speed values

With the ignition off, briefly press the control button (see. Fig. 1.76). This turns the lighting odometer.

Press the control button for 2 seconds. The display will show the maximum speed.

To correct speed setpoint is necessary to press the upper or lower side switch function on-board computer (Fig. 1.79). The values of the rate of change up or down in steps of 10 km / h. Lighting odometer turns off after a few seconds after adjusting speed value.

Cancel the programmed value of speed

With the ignition off, briefly press the control button (see. Fig. 1.76). This turns the lighting odometer.

Press the control button for 2 seconds. The display shows the set maximum speed.

Then press the ?�Reset?� on-board computer and hold it for as long as the display shows the symbol of a crossed-degree warning 2.