 printable version
Withdrawal
Before disconnecting the battery, check whether you have the code switch on the radio. Switch off the ignition and disconnect a wire of "weight" from the storage battery. Remove ribbed belt. Remove the viscous clutch fan radiator. Remove the timing belt. Drain the coolant.
| Fig. 7.25. Designated cooling system hose connections (1 and 2) for vehicles with petrol engines of 1.8 liters
|
Loosen the clamps and disconnect coolant hoses 1 and 2 (Fig. 7.25). Loosen the clamp and disconnect the upper radiator hose.
| Fig. 7.26. Location of the air pipe (1) and an electrical connector (2) increasing the pressure sensor
|
Disconnect the air tube 1 (Fig. 7.26), it does not disconnect the electrical connector 2 from the sensor to increase the pressure. Turn out bolts of fastening of the generator and remove it. After removing the generator disconnect the electrical wires. Remove the following bolts: - Bolts of rack intake manifold; - Support the bolts clamp compensator reactive moment; - Rack mounting bolts to the engine block.
| Fig. 7.27. The location and sequence of tightening of bolts (1-6) bracket of the generator, power steering pump and fan
|
Remove the bolts 1-6 (Fig. 7.27) bracket of the generator, power steering pump and fan.
Pos. | Bolt | Tightening torque Nm | 1 | M8h70 | 25 | 2 | M8h110 | 25 | 3 | M8h50 | 25 | 4 | M8h90 | 25 | 5 | M8h70 | 25 | 6 | M8h100 | 25 |
Take the bracket to the side and secure it with a soft wire. Disconnect the coolant hoses from the thermostat housing and the water pump.
| Fig. 7.28. Location bolts toothed belt to the water pump
|
Remove the water pump. If necessary, remove the screws and remove the water pump.
| 
