 printable version
Diagnostic functions
Switch off the ignition. Connect the instrument Hi-Scan Pro to the diagnostic socket on the dashboard. Turn on the ignition. The instrument Hi-Scan Pro, check the DTCs. Spend repair, guided by diagnostic trouble codes table.
WARNINGS The memory can be written eight fault codes in the order of their appearance. The same diagnostic code can be stored only once. If there is a fault, after the memory contains eight DTCs are erased fault codes, since the codes, which have been recorded at first. Do not disconnect the battery as long as all of the recorded read fault codes, since the battery is disconnected, they will be erased. |
If the system is activated in an emergency shut-and the gearbox is locked in third gear, in the memory (RAM) will be recorded DTC Emergency Timer. In this case, the memory can be recorded three DTC. Cancellation indications happen if the gearbox is locked in third gear, the ignition key is turned to the ?�OFF?�, and the DTC is written in RAM. Memory diagnostic codes: - In memory must be stored for up to eight diagnostic codes and three shut-codes; - If the memory is exceeded, the error codes in the memory is overwritten, starting with the most recent. - None of the diagnostic code can not be stored more than once. Removal of diagnostic codes: 1 - automatic removal: all diagnostic codes are deleted from the memory after 200 times, after the temperature of the working fluid of an automatic transmission reaches 50 ?� C, after storing of the new diagnostic code. 2 - forced removal of: stored diagnostic codes can be removed using a scanner, if the following conditions are satisfied: - The ignition is switched; - Absence of pulses from the angle sensor of the crankshaft; - No pulses from the speed sensor output shaft; - No pulses from the vehicle speed sensor; - Not activated fault in the accident.
| 
