 printable version
Design Features
Each wheel is composed of two constant-velocity joints; moreover, the right wheel drive shaft is provided with an additional intermediate support. Slotted tips of the yoke mounted in the front wheel hub and fasten them with nuts. The internal hinge of type "Tripod" consists of a body and three rollers on needle bearings, worn on a pin trehshipovoy hub. In the case of the hinge are made grooves for the rollers. Trehshipovaya hub fixed on a shaft locking ring and allow the rollers to move in the slots of the yoke in the axial direction, whereby the actuator can be extended or shortened to compensate for the mutual displacement of the suspension. In the outer hinge balls set a sorting group. Details joints are lubricated with special grease for constant velocity joints, which are laid in the case of the hinge is assembled. Sealing of joints is provided with rubber protective covers that attach tie straps. Drive shafts of the left and right wheels of the same length, but they are not interchangeable.
HELPFUL ADVICE Work on replacing drives the front wheels is quite time-consuming, and the drives are not cheap. to seriously save your time and money, and avoid damage to the protective covers of hinges (for example, collision with the wire sticking out of the ground) and immediately replace them at the slightest injury. If the hinge cover gets damaged by water or dust, it goes down a few hundred kilometers. Sealed joint wears out very slowly. |
| 
