REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Spectra (2004 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Spectra
		Device Car
		Operating Guidelines
		Faults in the way
		Maintenance
		Engine
		Transmission
		Chassis
		A steering
		The brake system
		Electrical
		Body
			Design Features
			Replacement bumpers
			Removal and installation of a mudguard and front wheel arch liner
			Removing and installing the rear wheel mudguard
			Removal and installation of a forward wing
			Removing and installing bonnet
			Door
				Removing and installing front door trim
				Replacing the glass front door
				Replacing the outer front door handle lock
				Replacing the front door lock
				Removing and installing front door
				Replacing the terminator of opening the front door
				Removal and installation of an upholstery of a back door
				Replacement glass back door
				Replacing the outer rear door handles
				Replacement lock the back door
				Removing and installing rear door
				Replace the rear door opening limiter
			The trunk lid
			Removal and installation of facing the boot
			The fuel filler flap
			Seats
			Supplemental Restraint System
			Rear view mirrors
			Dashboard
			Removal and installation of the instrument panel
			Heater and air conditioning
			Interior fittings
			Replacing a windscreen
			Care body
		Car Care
		Purchase of spare parts
		A trip to the STO
		Winter car operation
		Preparation for technical inspection
		Applications
		Diagrams

Removing and installing front door trim

You will need a screwdriver with a flat blade and Phillips.

1. Disconnect a wire from the plug ?�-?� the storage battery.


2. Remove the screw that secures the internal handle of the lock.	3. Hook traction drive lock, print them from clamps ...


... 4. Disconnect the two traction drive from the castle ...	5. ... and remove the internal handle to lock the car.


6. Remove the screw fastening ...	7. ... and prying with a screwdriver, remove the inside door handle.

8. Remove the two caps locks the front fastening of an upholstery ...

NOTE

Since the pistons are arranged front door trim attachment.


9. ... and remove the caps.	10. Remove the screw securing the rear door trim.

11. Overcoming the resistance of the plastic holder, remove the trim from the door.

NOTE

So arranged plastic holders door trim (view from the back of the upholstery). Damaged holders replaced.


12. Disconnect the wiring harness from the control windows and remove the door trim.	13. In order to gain access to the sites and units inside the door, remove the screw of the door handle ...


14. ... remove the bracket ...	15. ... and peel off the plastic on the door panels moisture proof film.

16. Install the front door trim and all previously removed parts in reverse order of removal.

« previos page
Door