add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 3 (2003 release)

general info. full specifications. diagnostics. hints. tips. tricks
Mazda 3
Home
 
Mazda
3
Operation and maintenance of car
Engine
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Overview
Power supply system
Lighting system
Front combination lamp
The rear combination lamp and internal combination lamp
Removing and installing front combination lights
Adjusting headlights
Adjusting low beam
Adjusting beam
Removing and installing the lamp lights
Removal and installation of a gas discharge lamp lights
Removing and installing parking lamp bulb
Removing and installing front turn indicator
Removing and installing the side direction indicator
Adjusting the front fog light
Removing and installing rear combination lamp
Removal and installation of domestic combined lantern
Removal and installation of a lantern of illumination of license plate
Removing and installing additional brake light in the rear spoiler
Removing and installing front interior light lamp
Removing and installing the door switch
Removal and installation of lighting lamps ashtrays
Removing and installing ignition backlight
Removal and installation of the backlight glovebox
Removal and installation of lighting control switch on the dashboard
Screen wipers and washer
Immobiliser
Electrical Inspections
Tables
Body
 


Hit Counter by Digits


print page printable version

Adjusting beam



Bring the tire pressure to normal.
Place unloaded vehicle on a level surface.
Put one person in the driver's seat.
Place the vehicle upright and perpendicular to the wall.
Install lights at a distance of 3 meters from the wall.
When adjusting one headlamp, close the other.
Start the engine to recharge the battery.
Turn-beam headlamps.
Set the headlight beam adjustment in the position 0.

Adjusting the rotation of the adjustment screws
Fig. 7.26. Adjusting the rotation of the adjustment screws


Adjust the headlights by converting the adjusting screws, as shown in Figure 7.26. First, loosen the screws, and then tighten them.




« previos page
Adjusting low beam
next page »
Removing and installing the lamp lights

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.