add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 3 (2003 release)

general info. full specifications. diagnostics. hints. tips. tricks
Mazda 3
Home
 
Mazda
3
Operation and maintenance of car
Engine
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Body
Overview
Mounted components of a body
Glazing Body
Seats
Air conditioning and heating
Refrigerant
Air filter
Block the air conditioning system
Evaporator
Expansion Valve
Capacitor
Check heat exchanger
Removing and installing rear duct
Removal and installation of the air conditioning system compressor
Dismantling and assembling freewheel
Adjusting freewheel
Checking freewheel
Removal and installation of the capacitor
Check capacitor
Removal and installation of refrigerant lines (LF)
Tables
 


Hit Counter by Digits


print page printable version

Removal and installation of the air conditioning system compressor



Disconnect the negative battery cable.
Discharge the refrigerant.
Remove the right mudguard and mud guard.
Loosen the belt tension and remove the belt.

ATTENTION
Contact with moisture or impurities in the cooling circuit of the cooling capacity of the circuit is reduced and abnormal noise is heard. Always stoppered open fittings after removing any elements of the cooling circuit to prevent the ingress of moisture or contaminants into the circuit.


Removing air conditioner compressor
Fig. 8.68. Removing air conditioner compressor: 1 - cooler hose (top); 2 - cooler hose number 4 (vehicles with left-hand steering); 3 - terminal magnetic coupling; 4 - the compressor air conditioning systems


Remove in the order indicated in Figure 8.68.
Install in the reverse order of removal.
Adjust the belt tension.
Perform the operational test conditioning system.




« previos page
Removing and installing rear duct
next page »
Dismantling and assembling freewheel

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.