REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 3 (2003 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	3
		Operation and maintenance of car
		Engine
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
			Overview
			Power supply system
				Accumulator battery
				Generator
					Checking on the vehicle
					Check current at the generator
					Removing and installing the generator
					Removal and installation of high-voltage wires
				Starter
			Lighting system
			Screen wipers and washer
			Immobiliser
			Electrical Inspections
			Tables
		Body

printable version

Removing and installing the generator

ATTENTION

When the battery is connected between the car body and the terminal may occur in the sample. This can lead to injury, fire or damage to the electronic components of the car. Always disconnect the battery before removing the alternator.

Remove the battery cover.

Disconnect the negative battery cable.

Remove the bottom cover together with the mudguard.

Remove the drive belt.

Secure the coolant expansion tank so that it does not interfere with work.

Attach the power steering reservoir so that it does not interfere with work.

Dismantling the components of the battery

Fig. 7.9. Disassembly of the battery components: 1 - Cable output B; 2 - plug the generator; 3 - Generator

Remove in the order shown in Figure 7.9.

Install in the reverse order of removal.

NOTE

Remove the bolt A generator, as the place is not enough to remove it (see. Fig. 7.9).

« previos page
Check current at the generator

next page »
Removal and installation of high-voltage wires