REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 3 (2003 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	3
		Operation and maintenance of car
		Engine
			General description new engines models L8, LF, L3
			The mechanical part of engines
			Appendix 1
			Annex 2
			Appendix 3
			Engine Z6 - mechanical part
			Lubrication system
			Cooling system
			Intake system
			Fuel system
				Removal and installation of the block of the fuel pump
					Withdrawal
					Setting
					Check fuel leakage after installing the pump unit
				Removal and installation of the fuel injector
			Exhaust and Emission
			Ignition system
			Control system
			Tables
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body

Setting

NOTE

If the gasket is gasoline, the fuel pump unit will rotate and can not be mounted in the specified position.

Thoroughly wipe off all gasoline from the pad.

Fig. 2.323. The combination of adjusting labels on the fuel pump and fuel tank

Align the timing marks on the fuel pump and the fuel tank, as shown in Figure 2.323.

Install special tool.

Using a special tool, tighten the fuel pump within the specified torque, preventing the displacement of adjusting labels.

If the specified torque can not be achieved, replace the fuel pump gasket.

If the specified torque can not be obtained after replacing the cover of the fuel pump and gaskets, replace the fuel tank.

Tightening torque cap of the fuel pump: 80-90 Nm.

« previos page
Withdrawal