 printable version
Setting
Install the dynamic damper, as shown in Figure 3.162. Standard Length: 334,7-340,7 mm. Install the new clamp cover a dynamic damper. Fill the boot (wheel side) with grease.
NOTE Covers and Wheel Side Transmission different. |
ATTENTION Do not touch the grease hands. Apply grease from the tube, do not let pollution into the case. Grease quantity: 90-110 g (L8, LF left side), 105-125 g (L8, LF right side and L3)
|
Install the cover without removing the tape, which was wrapped splined shaft during disassembly. Remove the tape.
| Fig. 3.163. Installing cage and balls in the clip: 1 - ceparator; 2 - balls; 3 - a lock ring groove; 4 - clip
|
Align the mark and set the balls and cage to cage in the direction shown in Figure 3.163.
ATTENTION Set separator chamfered towards the recess of the locking ring. If improperly installed, the drive shaft may disconnect during movement. |
Establish a new lock ring. Fill the joint housing and cover (Transmission) with grease. Grease quantity: 105-125 g (L8, LF left side), 120-140 g (L8, LF right side and L3). Align the mark and set the body on the shaft. Install a new clip. Install the cover. Set the standard length of the drive shaft. Let the air out of the case by lifting the edge of the smaller end covers with a screwdriver wrapped with a cloth. Make sure that the length of the drive shaft - within limits.
Standard length mm
| 
