 printable version
Electronic immobilizer (anti-theft system)
Your vehicle may be equipped with an immobilizer. Electronic immobilizer for the vehicle immobilizer and, thus, the probability of theft is minimized. Anti-theft system - immobilaizer allows you to start the vehicle only if registered in the worn card ?«Advanced Key?».
ATTENTION When starting the engine auxiliary key (for example, in the case of battery discharge wearable card ?«Advanced Key?» or breach of its efficiency) follow the recommendations listed below. Otherwise the system can not correctly receive the signal from the auxiliary key, and the engine will not start. |
Anti-theft system (immobilaizer) is activated by turning the ignition switch from position ?«ON?» (ignition on) to the "ACC" (auxiliary power consumers) or ?«LOCK?» (locking). The immobilizer indicator located on the dashboard will flash at a frequency two seconds until immobilaizer is turned off.
Turning off the immobilizer. Anti-theft system (immobilizer) is turned off when you turn the ignition switch to ?«ON?» (ignition switched on) if you are a registered system worn map ?«Advanced Key?». This immobilizer indicator lights up for about 3 seconds and then goes out. If the engine does not start in the presence of a registered card and the immobilizer indicator stays on continuously or flashing, it may be a problem with the anti-theft system. The engine can not be started, and the immobilizer indicator can burn continuously or flashing when the card is worn in such a zone, where the system can not reliably detect the signal, such as a control panel or in the glove box. Put wearable card to another location, turn the ignition switch to ?«LOCK?» (locking), and then try to start the engine. The signals from the TV and radio stations from transceiver or a mobile phone may be interfering with the work of an immobilizer. If you are using a registered worn cards ?«Advanced Key?» engine does not start, note the immobilizer indicator. If the immobilizer indicator blinks, turn the ignition switch to "ACC" (auxiliary power consumers) or ?«LOCK?» (lock) and take a small pause. Then try to start the engine.
| 
