 printable version
Overview
Additional passive safety system (SRS) includes two main subsystems: - A system of airbags with gas generators; - Electrical system with shock sensor module and fault diagnosis.
| Fig. 7.99. Passive safety car Mazda 6: 1 - warning lamp airbags; 2 - a spring; 3 - the driver airbag module; 4 - passenger airbag module; 5 - the gauge of collision zone; 6 - unit SAS; 7 - indicator lamp off the passenger airbag; 8 - side airbag sensor; 9 - seat belt pretensioners; 10 - side airbag module; 11 - seat occupancy sensor; 12 - Module curtain airbags
|
Airbags are installed on the vehicle in the following locations: the hub of the steering wheel, the front panel (right side), front seatbacks (door side), front and rear-pillar, as well as along the edge of the ceiling above the side door openings. Airbags and inflatable curtains are installed covertly and are not visible until the response (Fig. 7.99 and 7.100).
| Fig. 7.100. Wiring diagram of the passive bazopasnosti 1 - unit SAS; 2 - seat occupancy sensor; 3 - detection bad contact; 4 - the gauge of collision zone; 5 - twisted pair; 6 - connector link; 7 - a combination of devices; 8 - a control lamp air bags; 9 - indicator lamp off the passenger airbag; 10 - the gauge of the driver's airbag; 11 - the gauge of the passenger airbag; 12 - a spring; 13 - supercharger number 1; 14 - supercharger number 2; 15 - the driver airbag module; 16 - passenger airbag module; 17 - safety belt pretensioners driver; 18 - unit driver curtain airbags; 19 - unit driver side airbag; 20 - seat belt pretensioners passenger; 21 - Module curtain airbags passenger; 22 - Module passenger side airbag
|
| 
