REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 6 (2002 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	6
		Operation and maintenance of car
		Engine
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body
			Overview
				The design of the car with a body "sedan"
				The design of the car with a body "hatchback"
				Body shell
				Curtain and decorative components of a body
				Door
				Windows
				Disassembly and assembly of the boot lid
				Removing and installing front bumper
				Disassembly and assembly of the front bumper
				Removing and installing rear bumper
				Removing and installing rear trim
				Removing and installing rear spoiler
				Outside mirrors
				Removal and installation of external electric mirrors
				Disassembly and assembly of the external electric mirrors
				Rear Defrost
				Sunroof
				Seat belts
				Seats
			Air conditioning and heating

printable version

Removing and installing front bumper

Disconnect the negative battery cable.

Fig. 8.39. Disconnecting the castle bumper

Pull the ends of the front bumper (Niche wheels) outward to disengage the lock bumper (Fig. 8.39).

Fig. 8.40. Removing front bumper: 1 - screw A; 2 - connector A; 3 - screw B; 4 - a bolt; 5 - connector B; 6 - the front bumper

Remove in the order shown in Figure 8.40.

Remove the front bumper.

ATTENTION

If the front bumper is released on one side only with the fall of the bumper, it can be damaged. When releasing the lock of the front bumper, attach the bumper so that it does not fall.

Spread the ends of the front bumper (wheel well).

Attach the front bumper to the body.

Push the connecting portion of the front bumper towards the bodywork in order to insert them into the locks of the bumper.

Install in the reverse order of removal.

« previos page
Disassembly and assembly of the boot lid

next page »
Disassembly and assembly of the front bumper