 printable version
The procedure to reprogram the immobilizer
| Fig. 7.78. When the client has two or more valid keys
|
NOTE If you still can not reprogram the immobilizer, check the number of working keys. |
Replace the key or do the reprogramming procedure with the addition of keys. To produce a duplicate key or replacing the immobilizer (key and / or a block of PCM), the client must bring all the keys dealer. This is due to the fact that pre-programmed key ID erased the PCM when re-programming. You can not rearrange the PCM from another vehicle. Otherwise, the engine will not start. Do not replace the PCM new to check when troubleshooting. Key ID and the code word to be programmed in the new block, and it can not be used later for other cars, even if you find out that the old unit is OK. Alarm can not be disabled. Make sure that all registered keys allow you to start the engine after the reprogramming procedure. Wait at least 5 seconds before using the next key. When the client does not need to register more than two keys, the following operations can be terminated after the registration of the two keys.
| 
