 printable version
Withdrawal
Drain the oil from the gearbox. Remove the sensor anti-lock braking systems.
With the help of a special device, remove the ball rod end (Fig. 3.126).
| Fig. 3.127. Remove the lower ball joint adjustable arm
|
With the help of a special device, remove the ball joint of the lower rear of the lever (Fig. 3.127).
Remove the rear brake caliper and hang it on the wire (Fig. 3.128).
ATTENTION Sharp edges of the connecting shaft can be cut or break through the gland. Be careful when separating the connecting shaft of the transmission. |
| Fig. 3.129. Installing the special tool to hold the side gear
|
Pull the connecting shaft directly. Install the special tool to hold the side gear after the removal of the connecting shaft in the gearbox. The remaining components are removed and installed in the reverse order of removal.
| Fig. 3.130. Installation of the new clip on the connecting shaft
|
Before installing the set on a new connecting shaft clamp slot upward (Fig. 3.130). After setting the outer diameter measure. If it is higher than normal, repeat installation using a new clip. Maximum outer diameter: 31.2 mm.
| 
