 printable version
Withdrawal
| Fig. 3.146. Removing the cover clamp (wheel side) with special pliers
|
Remove the cover clamp (wheel side) with special pliers, as shown in Figure 3.146. Bend the screwdriver locking Clamp.
| Fig. 3.147. Removing the cover clamp (Transmission)
|
| Fig. 3.148. Marking on the joint housing and drive shaft
|
Remove the hinge.
| Fig. 3.149. The marking on the drive shaft and tripod
|
Remove the lock ring using pliers for removing and installing the retaining rings. Remove tripodnoe connection to the shaft.
ATTENTION Do not use hammer blows to the tripod. |
NOTE Case wheel side does not have to be removed, except replacing the cover, a shaft or a ball joint. Do not remove the tape until the bag is not collected. |
Remove the cover.
NOTE Do not remove the rotor sensor anti-lock brake system (vehicles with anti-lock brake system), if it is required. Do not reuse the removed rotor sensor. |
| Fig. 3.151. Removing the rotor sensor anti-lock braking system of the drive shaft
|
Beat the rotor sensor anti-lock braking system of the drive shaft chisel (Fig. 3.151). Remove the dynamic damper.
| 
