REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 626 (from 1991 to 1998, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	626
		Instructions
		Maintenance
		Engines
		Heating and ventilation
		Fuel system
		An exhaust system
		Transmissions
		Coupling and semiaxes
		The brake system
		Chassis
		Body
			Introduction
			Maintenance and repair of body
			Vinyl trim
			Repair of insignificant damages of a body
			Repair of considerable damages of a body
			Hinges and locks
			Replacing windshield and windows neopuskayuschihsya
			Replacement grille (model Mazda 626)
			Hood
			Bumpers - removal and installation
			Front fender
			The plastic panel before a windshield
			Door trim panel
			Door
			The door lock, the drum lock and handle
			Glass doors
			Mechanism window
			Rear view mirrors
			The trunk lid (the Mazda 626 and MX-6)
			Castle and lock drum lid (model Mazda 626 and MX-6)
			Ropes opening the boot lid / fuel filler flap
			The back door (model Ford Probe)
			Lock the back door and the lock drum (model Ford Probe)
			The support legs tailgate / boot lid (model Ford Probe, MX-6)
			The center console
			Panels finishing dashboard
			Column cover
			Dashboard
			Seats
		Electrical
		Wiring
		Tips and Tricks

Hood

Refitting

PERFORMANCE ORDER

1. Open the hood.
2. Disconnect the wires and hoses, preventing the removal of the hood.
	3. Mark the installation position of the loop on the hood.
	4. Turn off fixing bolts and remove the hood.
5. Installation is spent upside-down removals.

Adjustment

PERFORMANCE ORDER

1. Loosen the screws or nuts and slide the hood, as needed. Tighten mounting bolts.
	2. To adjust the position of the bonnet, loosen the fixing bolts of the lock and move the lock as required.
	3. Adjust the height of the rubber cushions hood.
4. Periodically lubricate the lock and hinge grease lithium based.

Hood lock - removal and installation

PERFORMANCE ORDER

	1. Mark the installation position of the castle. Remove the trim panel from the top of the castle. Turn off fixing bolts and nuts, and remove the lock.
	2. Remove the retaining clip.
	3. Disconnect the end of a rope.
4. Installation is spent upside-down removals.

A rope of opening of the lock - removal and installation

PERFORMANCE ORDER

1. Disconnect the cable from the bonnet.
2. Tie a length of wire or thick thread to a rope and remove the rope from the mounts in the engine compartment.
3. Remove insert the wheel house.
	4. Turn off fixing screws (arrows) and remove the hood release handle and a rope from the instrument panel.
5. Pull the cable into the cabin, and remove it from the car.
6. Installation is spent upside-down removals.