 printable version
Removal and installation of the rotary switch with a spiral spring (only for complete dual airbags)
| Fig. 9.53. Rotary switch: 1 - label on the rotor; 2 - a label on the fixed part; 3 - the bolts
|
Remove the airbag on the driver side. Disconnect the audio signal, and remove a steering wheel, the front wheels must be in the straight running. Remove a casing of a steering shaft. Remove the four screws on the switch (Fig. 9.53), disconnect the plug connector and remove rotary switch. Before installing, make sure that the front wheels are in position for rectilinear movement. Set the rotary switch, aligning the mark 1 (see. Fig. 9.53) on the rotor with the mark 2 on the fixed part. Connect the plug connector and tighten the screws that secure the switch. Establish a casing of a steering shaft. Install the steering wheel and the airbag unit, connect the wires to the plug strip and pillow block to the audio signal.
| 
