| 1. Remove the machine parts that prevent access to the appropriate cover cast holes. |
| 2. Insert a screwdriver or chisel on the narrow edge of the cover. |
 | 3. Gently bumped into the locking cap (121) on the one hand as long as it does not turn by 90 ?°. |
 | 4. Turn the cover pull using tongs. |
 | 5. Carefully clean the hole of the molten fat. Sealing surface (arrow) must be free of deposits. |
| 6. Cover the sealing surface with sealant (eg, Loctite N241 or Curil). |
 | 7 will drive a new sealing cap suitable pin. Allow to cure the sealant in accordance with the manufacturer's instructions (about 45 min.). |
| 8. Place the disassembled parts of the unit. |
| 9. Fill up with coolant. |
| 10. Warm up the engine, check the coolant level and sealing lids of cast holes. |
