 printable version
The cuffs of hinges of steering trapezoid
Defective cuff should be promptly replaced, t. To. Penetrated into the hinge dirt renders it incapable in a short time. In doubtful cases, the tip of the lever is replaced or the entire steering linkage assembly. Withdrawal | PERFORMANCE ORDER | | 1. Remove the steering linkage. | | 2. Remove the flat spring ring (3) using a screwdriver. | | 3. Remove the collar (2) with round spring ring (10) up. | | 4. Note: If the cuff of the ball joint between the lever and pull the trapeze act in the same way, but must be unscrewed before the tip of the lever. |
|
Setting | PERFORMANCE ORDER | | 1. Remove grease and fill ball hinge of about 3 cm 3 of a multi-purpose lubricant, for example, Shell Retinax A. | | 2. Insert a new spring ring (10) of circular cross section in the rubber sleeve. | | 3. The rubber sleeve (2) through the slide pin of the hinge. | | 4. A flat spring ring (3) using a screwdriver set with rounded edges to prevent damage to a rubber cuff. | | 5. Replace the steering linkage. |
|
|
